What should you do if the air conditioner keeps tripping the breaker?
You can safely reset the breaker once. Set the thermostat to off first, then reset the breaker and wait a few minutes before setting it back to cool. If it trips again, leave it off. A breaker that keeps tripping is protecting the wiring. Resetting it over and over can overheat a connection or damage the compressor.
The usual causes are a weak start capacitor, a worn contactor, a fan motor drawing too much current or a compressor that struggles to start. A capacitor can hold a charge after the power is off, so do not open the panels on the outdoor unit yourself. The technician isolates the power, tests each part with a meter and shows you which one has failed.
Why is it running but not cooling the house?
Start with the things that are safe to check. Make sure the thermostat is set to cool and a few degrees below the room temperature. Look at the furnace filter, because a clogged filter starves the indoor coil of air. Then go outside to the outdoor unit. Check that the fan is turning and that leaves, grass clippings or seed fluff are not packed against the fins. Switch the power off at the outdoor disconnect and clear away what you can by hand.
If the indoor fan runs but the outdoor unit is silent, the problem is usually electrical: a capacitor, a contactor or a thermostat wire. If both units run but the air is only cool, not cold, the system may be low on refrigerant. Refrigerant does not get used up. If the level is low, there is a leak, and topping it up without finding the leak only works for a short while. The technician measures pressures and temperatures, looks for the leak and tells you plainly whether it can be repaired.
Why is there water by the furnace, or ice on the lines?
An air conditioner takes moisture out of the air. That water collects in a pan under the indoor coil, then runs through a small tube to a floor drain or a condensate pump. Water on the basement floor near the furnace usually means the drain line is blocked or the pump has stopped. Turn the cooling off and wipe up the water. It is not dangerous, but it can soak a finished floor or reach the furnace controls.
Ice on the copper line at the outdoor unit, or frost on the indoor coil, usually means too little airflow or too little refrigerant. Set the thermostat to off and the fan to on, then let the ice melt completely before you run cooling again. If the coil freezes a second time, it needs a technician.
Why is one floor warmer than the rest of the house?
Sometimes the equipment is working and the house itself is the limit. Homes in West Ridge and the newer parts of West Orillia were built with forced-air gas furnaces and ducting for central air, so cool air can usually reach every room. There, the usual trouble is original builder-installed equipment reaching the end of its service life.
The wartime and 1950s houses around Westmount Drive, Argyle Street and Albany Street often have small, sparse ductwork, with weak airflow to the upper half-storey. Cool air sinks, so those upstairs rooms can stay warm even when the system is working as it should. The technician checks the airflow at the registers before blaming the equipment.
Orillia's oldest homes, such as the Queen Anne houses on Mary Street and Mississaga Street West, were built for stoves and coal. In these houses a technician often finds undersized duct runs, or no ductwork for central air at all. Repairing the outdoor unit will not change what a small duct can carry. If your house has no ducts, the air conditioning installation page explains the options.
Is it worth repairing, or is it time to replace?
A small electrical part on a system that is otherwise sound is usually worth repairing. A failed compressor, or a leak in the outdoor coil of an older unit, is a harder decision. You get the repair price in writing, and where replacement is a reasonable choice, a replacement price beside it, so you can compare the two and decide.
If the air conditioner and furnace are about the same age, ask about both. Before you decide, check the manufacturer's warranty paperwork, since some parts warranties depend on registration and regular maintenance. The guide is it worth repairing an air conditioner goes through the decision step by step. If you are thinking about one system for heating and cooling, read about heat pumps.
How does a repair visit go?
The technician starts by asking what you have noticed and when it began. Then they check the thermostat, the filter, the indoor coil and drain, and the outdoor unit. Electrical parts are tested with meters, and refrigerant pressures are measured with gauges. You see what was found and approve a written price before any part is fitted.
Work is performed by 313A refrigeration and air conditioning mechanics. Refrigeration and air conditioning is a compulsory trade in Ontario, so refrigerant work is not a do-it-yourself job. In most Orillia homes, central air shares the furnace blower and ducts. When the fault turns out to be in the gas furnace itself, work is performed by TSSA-certified gas technicians.
If your air conditioner stopped in late summer and has been off since then, there is no need to rush. A visit in autumn or spring lets it be checked before the next hot spell. See furnace and AC maintenance, or request a quote.
