Is it normal for my heat pump to blow cooler air or give off steam?
Often, yes. A heat pump sends out air that feels warm rather than hot. To your hand it feels cooler than air from a gas furnace. It makes up for this by running longer, steadier cycles. If the house stays at the temperature on the thermostat, the system is working as it should.
In cold, damp weather, frost builds up on the outdoor coil, and every so often the unit runs a defrost cycle. The outdoor fan stops, you may hear a whoosh, and steam rises from the unit for a few minutes. That is normal. A coil that stays white with ice for hours is not. Neither is a unit covered in solid ice, or a house that keeps getting colder than the thermostat setting.
Other signs worth a call:
the system runs without stopping and the house still cools down; the breaker trips; water drips from the indoor unit into the room; a ductless head shows a flashing light; or a hybrid system never switches over to the furnace. If the trouble is on the furnace side, see furnace repair.
What is safe to check before you call?
Start outside. Environment Canada issues snow squall alerts for the Barrie - Orillia - Midland region, and lake effect squalls off Georgian Bay can pile snow against an outdoor unit overnight. Clear the snow away by hand or with a soft brush, and leave space on all sides so air can flow. Do not chip or pry at ice on the coil. The fins bend easily, and the refrigerant lines sit just behind them.
Inside, make sure the thermostat is set to heat, and not to cool or emergency heat by mistake. Check that the filter is not clogged and that the breaker for the outdoor unit has not tripped. Beyond those checks, keep the panels closed. Refrigeration work is a compulsory trade in Ontario, and the electrical parts carry high voltage.
If you have a hybrid system, the gas furnace is still part of it. The Ontario Fire Code requires a working carbon monoxide alarm next to each sleeping area in a home with a fuel-burning appliance. If the alarm sounds, leave the house and call the fire department from outside. On the furnace side, a cracked heat exchanger is the fault that can let carbon monoxide into the air, and it should never be left running.
Which kind of heat pump suits my house?
Mostly it depends on whether the house has ducts and what condition they are in. Orillia's houses were built in waves. The 2021 Census counts 4,510 of the city's 14,425 occupied dwellings as built in 1960 or before.
Homes built in West Ridge and West Orillia from 1998 onward came with forced-air gas furnaces and ducting for central air. A ducted cold-climate heat pump can usually use those ducts. It often replaces the old outdoor air conditioner and works alongside the existing furnace or a new one. Older homes, such as the Queen Anne houses on Mary Street and Mississaga Street West, were built for stoves and coal. Many now have radiators and no ductwork at all. In those homes, ductless heads mounted in the main rooms are usually the practical choice, and the boiler can stay. Wartime and 1950s houses around Westmount Drive, Argyle Street and Albany Street tend to have small, sparse ducts. We measure them before we tell you whether a ducted unit can move enough air to the upper half-storey. For more on ductless systems, see air conditioning installation.
North of the city, Washago and the surrounding parts of Severn have been beyond the gas main. On July 21, 2026, the Ontario Energy Board approved an Enbridge pipeline project there, with service planned to start in the 2027/2028 heating season. If you live in that area, you can put in a heat pump now, install a hybrid system with your current fuel, or wait for gas. We can talk the choices through with you.
How does a hybrid system share the work with a gas furnace?
A hybrid system pairs a heat pump with a gas furnace on one thermostat. The heat pump heats the house through the milder months of spring and fall. When the outdoor temperature drops below a set switch point, the furnace takes over. Enbridge Gas supplies natural gas in Orillia. Environment Canada's normals for mid-November are a high of 5°C and a low of -3°C, so much of the heating season falls in a range where a cold-climate heat pump works well.
We set the switch point with you, based on the house, the equipment and what matters most to you. It can be changed later. The furnace side is installed to the CSA B149.1 code, the same as any gas appliance. Work is performed by TSSA-certified gas technicians. If the furnace itself is due for replacement, see furnace installation and replacement.
How are current rebates checked before you commit?
Programs change, so this page does not quote amounts. The City of Orillia points homeowners to Save on Energy, Enbridge and Natural Resources Canada's directory of energy efficiency programs to find what is currently offered.
Program rules can set conditions on timing and on which equipment qualifies. Before you sign, we go through the current conditions with you, so the system you choose and the order of the steps fit the program. Our guide to heating and cooling rebates in Ontario explains where to look.
How does a heat pump installation go?
It starts with a visit to look at the house: the insulation, the windows, the ducts or the lack of them, the electrical panel and a spot for the outdoor unit. The system is sized to the house, not to the label on the old furnace or air conditioner. Our guide on why the old label is not the answer explains how sizing works.
Outside, the unit goes on a stand or wall bracket that keeps it above the snow and out from under roof drips, with room to drain during defrost. You get a written price and approve it before work begins. Work is performed by 313A refrigeration and air conditioning mechanics.
After installation, a yearly check keeps the system running well and helps you meet the manufacturer's warranty conditions. See furnace and AC maintenance. When you are ready, you can request a quote.
