What signs mean the furnace should be looked at soon?
Two situations come before any tune-up. If a carbon monoxide alarm is sounding, get everyone out of the house and call emergency services once you are outside. If you smell gas, leave the house and call Enbridge Gas, the natural gas utility for Orillia, from outside. Neither should wait for a routine visit.
Most other signs are not emergencies, but they are worth a visit. The furnace starts and stops in short bursts. The burner flame looks lazy, yellow or lifting instead of steady and blue. There is soot or rust around the cabinet or the vent pipe, or you hear a new rumble, squeal or bang on start-up. Upstairs rooms are colder than they used to be, or the gas bill climbs without colder weather. These usually point to ordinary wear: a clogged filter, a dirty flame sensor, a blocked condensate line or a tired blower motor.
A tune-up also looks for one real danger. A cracked heat exchanger can let combustion gases, including carbon monoxide, into the air the furnace blows through the house, and you cannot see it from outside the cabinet. A furnace with a cracked heat exchanger should not be run, and the technician will explain your options if one is found.
Is mid-November too late to book a tune-up?
No. Autumn, ahead of the cold, is the best time. Environment Canada gives Orillia's mid-November normals as a high of 5°C and a low of -3°C, so overnight lows are already below freezing and most furnaces are running by now. A furnace that is already in use can be serviced the same way; it is turned off for part of the visit.
For the air conditioner, spring works best, before the first warm spell. Coils, drains and electrical parts are easier to deal with before the system is needed every day.
What is safe to check yourself between visits?
A few things are safe for any homeowner to check. Make sure the thermostat is set to heat and has fresh batteries if it uses them. Check that the furnace switch, which looks like a light switch on or near the unit, is on. Look at the filter and replace it if it is grey and clogged.
If your furnace vents through two plastic pipes in the side wall, as many in West Ridge and West Orillia do, keep them clear. Environment Canada issues snow squall alerts for the Barrie, Orillia and Midland region, with lake effect snow off Lake Huron and Georgian Bay, strong northwest winds and blowing snow. A drift over those pipes makes the furnace shut itself off for safety. Clear them by hand, then switch the furnace off and on again. Keep snow off the outdoor air conditioning unit too.
Test your carbon monoxide alarms. The Ontario Fire Code requires a working carbon monoxide alarm next to each sleeping area in a home with a fuel-burning appliance, a fireplace or an attached garage.
Some things are best left alone. Do not take panels off a running furnace, adjust the gas valve or touch refrigerant lines. That work belongs to a technician.
What happens during a furnace tune-up?
The technician starts by asking what you have noticed, then shuts the furnace down and works through it. They clean the burners and flame sensor and look at the igniter. They test the safety switches and clear the condensate drain and trap. They check the blower, measure gas pressure and temperature rise, and inspect the heat exchanger and the venting. When the furnace is running again, they test for carbon monoxide around it. Work is performed by TSSA-certified gas technicians, as Ontario Regulation 212/01 requires for gas appliances, and to the CSA B149.1 installation code.
The age of the house matters too. More than half of Orillia's occupied homes were built in 1980 or earlier. In older homes, such as the converted houses around Mary Street or the wartime houses on Argyle and Albany streets, the furnace may still vent into an old masonry chimney, and the ducts may be small and sparse, with weak airflow upstairs. The technician checks how the vent is drafting and tells you whether the duct layout explains a cold room.
In West Ridge, where homes went up from 1998 onward, much of the original builder-installed equipment is now getting older, so the side-wall vent connections and the condensate system get a careful look. If the furnace is near the end of its working life, you will hear that plainly, along with what replacement would involve.
What happens during an air conditioner tune-up?
The technician cleans the outdoor coil and checks the fan. They clear the indoor condensate drain, tighten and test electrical connections, check the capacitor and contactor, and measure how well the system is cooling. Refrigerant is only checked or handled by someone qualified to do it. Work is performed by 313A refrigeration and air conditioning mechanics.
If the system is running but not cooling well, leaking water or tripping the breaker, that is a repair rather than a tune-up. See air conditioner repair and our guide on whether to repair or replace an air conditioner.
How does maintenance affect the manufacturer warranty, and what if something is found?
Many manufacturer warranties on furnaces and air conditioners ask for regular professional maintenance, and some ask for proof of it. The exact conditions are in the warranty document that came with the equipment, and they differ between makers. The technician can walk you through what yours asks for. Keep the invoice from each visit with your warranty papers; if you ever make a claim, those records are what the manufacturer will want to see.
A clean filter, burner and coil also let the system run the way it was designed to, which is easier on the equipment and on your bills.
If the tune-up turns up a worn part, you get a written price before anything is replaced, and the decision is yours. You can request a visit or read more in our questions and answers.
