Is your air conditioner telling you it is time to replace it?
You are probably seeing central air that runs but does not keep up, or a system that has needed more than one repair, and you are wondering whether to keep going. A few things are safe to check yourself. Look at the furnace filter, because a clogged one starves the indoor coil of air. Check that the breaker for the outdoor unit has not tripped. Make sure leaves, grass clippings or a fence panel are not crowding the outdoor unit. If cooling comes back, the system may only need a repair or regular maintenance.
Replacement starts to make sense when the same faults keep coming back. That means a refrigerant leak that returns after each top-up, a compressor that keeps tripping the breaker, or a coil that keeps icing over. It also makes sense when the outdoor unit has reached the end of its service life along with the furnace it was installed beside. If the breaker trips again after one reset, leave it off and let a technician look. An air conditioner that has stopped cooling is uncomfortable, but it is not a danger to the household, so you can take time to decide. Our guide on whether to repair or replace an air conditioner explains how to weigh it up.
Can central air go into your kind of Orillia house?
Orillia's housing is older than many people expect. The 2021 Census counts 14,425 occupied private dwellings in the city. Of those, 4,510 were built in 1960 or before and another 3,855 between 1961 and 1980. How easy central air is to add depends mostly on which of these groups your house falls into.
In West Ridge and West Orillia, where homes have been built from 1998 onward, the houses came with forced-air gas furnaces and ducting meant for central air. Installation there is usually simple: a new outdoor unit, a matching coil on the furnace and new refrigerant lines. Much of the builder-installed equipment in these homes is now reaching the end of its service life, so the furnace and air conditioner are often looked at together. See furnace installation and replacement.
The wartime and post-war houses around Westmount Drive and on Argyle and Albany streets had gravity or early forced-air furnaces that were later converted to gas. The ducts in these homes tend to be small and sparse, and the upper half-storey gets weak airflow. Central air can work here, but the upstairs will stay warm unless the air can reach it. We look at the duct runs and tell you whether adding a supply or return will fix it, or whether a single ductless unit upstairs is the better answer.
What if the house was built without ductwork?
Orillia's oldest homes include the Queen Anne style houses on Mary Street and Mississaga Street West, the Art Deco house on Laclie Street and a home built around 1875. Houses of that age were built for stoves and coal. Many were later given hot-water boilers with radiators, so there are often no ducts to carry cool air. Cutting new ducts through plaster walls and finished ceilings is rarely practical.
A ductless system avoids that work. An outdoor unit connects to one or more wall-mounted indoor units through a small refrigerant line and a cable that pass through a hole in the wall about the width of a fist. You choose which rooms get an indoor unit, so a bedroom floor can be cooled without touching the rest of the house. The boiler and radiators stay as they are.
Many ductless systems are heat pumps, so they can heat in the spring and fall as well as cool in summer. If that interests you, read about heat pumps. The City of Orillia points homeowners to Save on Energy, Enbridge and Natural Resources Canada's directory to find current rebate programs. Our rebate guide explains how to check what is offered before you commit.
How is the right size worked out?
The label on the old air conditioner tells you what was installed. It does not tell you what the house needs. Windows may have been replaced, the attic may have been insulated, or an addition may have been built since then. We look at the floor area, the windows, the insulation, which way the house faces and the condition of the ducts.
Getting the size right matters for comfort. A unit that is too large cools the air quickly and shuts off before it has taken the moisture out, so the house feels cool but clammy. A unit that is too small runs all afternoon on the hottest days and still falls behind. With central air, the furnace blower moves the cool air, so the blower, the coil and the outdoor unit all need to be matched. The same thinking applies to heating, and our guide on furnace sizing explains it in more detail.
How does an installation go from first visit to start-up?
The first visit is for looking. The technician checks the ducts or the rooms you want cooled, the electrical panel and where the outdoor unit can go. In newer Orillia homes, outdoor units often get buried in snow, so we place the unit on a pad or stand where drifts and snow sliding off the roof are unlikely to reach it. You then get a written price, with options where there are real choices to make, and you approve it before any work begins.
On installation day, the refrigerant lines are run, then the system is pressure tested, evacuated and charged. Once the electrical connections are made, the system is started and we check temperatures and airflow. Work is performed by 313A refrigeration and air conditioning mechanics. If the furnace is replaced at the same time, work is performed by TSSA-certified gas technicians.
Before leaving, the technician shows you how to use the thermostat or remote and how to change the filter. They also explain what the manufacturer needs from you to keep the equipment warranty valid, which usually means registering the equipment and having it serviced. Many homeowners plan an installation in the cooler months, when the old system is not needed and there is time to compare options without pressure.
